Open the ‘Notes’ App from your iPad.
Step 2
Place the cursor where you want to enter data.
Step 3
Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the trigger button. An aiming beam will appear for 3 seconds. Keep your hand steady while scanning.
* After data is read and sent to the Apple device, by default, the CHS will beep once and vibrate, the LED will flash green, and the beam will turn off.
* A double click on the Scanner’s power button will suspend barcode scanning and will allow you to use the mobile device keyboard.
Step 4
If the above procedures were performed correctly, the scanned code should appear on the line where the cursor was blinking. If no code appeared, then follow the steps in page 9 and repeat the steps from page 4.